![]() ![]() Right now as I see on DWG printing page it shows that canoe is divided into two. (But the person is using lower Inventor version) I liked Inventor because of the idea that you can change measurements even when the drawing is finished.Īnd I have tried to change the curvature of the line which defines the upper bent part of the canoe (nose). In the video I followed the measurement was changed from 600 to 800 - easily, no glitches. But If I choose 650 or even 620 - message "Error occurred during update" comes out again. As you said - its no problem to change from 600 to 601 - up to 610. I've updated Inventor - but before and after it's still the same. ![]() Thank you - I can't take all the credits to myself - I followed some tutorial on youtube and changed few details to make sure I understood Inventor modelling. ![]()
0 Comments
Leave a Reply. |